engine error 1160 - Seiko 64S

[mr.alexei]

Всем привет. помогите, кто знает. Seiko 64S выдает ошибку engine error 1160, что делать?

[vas]

mr.alexei
Попробовать почитать документацию например.....

[vas]

5.5.2.6 Engine error 1160: Wiping error
<Description>
When the wiping motor is run for a while, the sensor does not make a response that indicates that the motor turns one turn.
This error is checked during wipe.
<Defective module>
(1) Wiping unit (including wiping motor and wipe sensor.)
(2) Sensor cable
(3) IPB1 board
<Measure to be taken>
Check whether the wiper turns one turn and the wipe sensor detects the turn during the initializing sequence at powering on the printer.
A. When the wiper does not turn.
(1) Check whether there is no step-out of the gears when the wiper does not turn one turn
even though the motor turns.
(2) Check whether 24 V is supplied to the IPB1 board with the circuit tester when the
motor does not turn.
When the motor does not turn even though the + 24 V is supplied, there is a possibility of the capping motor defect.
Replace the capping unit.
(3) Check the sensor cable.
(4) There is a possibility of a motor drive circuit defect.
Replace the IPB1 board.
B. When the wiper turns
(1) Check whether the wipe sensor can be switched ON and OFF by rotating the wiper.
Check whether the lever type switch is not loosen.
(2) Check the sensor cable.
(3) Replace the IPB1 board.

[burka]

Alexei. Здравствуйте. Проблема механическая не отходит язычок.

[mr.alexei]

Спасибо, действительно контакт не правильно замыкался.